AudioControl Product FAQs
General help and information when installing car-audio products
- Making your own PFM module
- Active vs Passive Crossovers in an Audio Systems - What's the difference?
- Where are the jumpers on the DQDX?
- Is the crossover on the DQDX just for the sub channel?
- How do I adjust the input gains on my DQ-61/DQDX?
- Does the sub channel output of my DQ-61 have a low pass?
- Can I bypass my factory amp?
- What is the minimum and max input of my line converter?
- What gauge wire should I use for speaker, power and remote trigger?
- AC LGD’s: Do your line converters put a resistor load on the speaker outputs of my factory amp?
- How do I adjust Signal Delay on my DQ-61 if I have a right handed driver car?
- My new LC2i is black. Is there any difference between the black one and the silver one?
- Could I get a replacement dash knob for my ESP-2/3?
- What do the lights on my remote knob for my DQDX/DQ-61 mean?
- What type of cable is used for my ACR remote dash knob?
- What ACR remote knob will work with my original Epicenter or Epicenter Series 2?
- What does the ACR-3 control on the Epicenter 600/1200 amplifiers?
- Is the Epicenter knob a bass volume knob?
- Do I need to send a full range signal or just a sub woofer signal to my epicenter?
- Should I put the Epicenter before or after my EQ?
- What is the difference between Accubass and the Epicenter?
- How does the Epicenter work?
- Where is the jumper location on my unit?
- Do I need an 18 db crossover module, or a 24 db crossover module?
- Can my multi channel line converter take a single stereo input and distribute it to all outputs?
- Should I sum the outputs on my line converter?
- What is M.I.L.C.?
- How do I set the output gains on my line converter to match the input sensitivity of my aftermarket amplifier?
- Do I need to connect the “remote in” in order for the “remote out” to work on my line converter?
- How many devices can I connect to the remote out?