Josh Cramer
- Total activity 238
- Last activity
- Member since
- Following 0 users
- Followed by 1 user
- Votes 1
- Subscriptions 121
Activity overview
Latest activity by Josh Cramer-
Josh Cramer created an article,
Problems Connecting to DM Smart DSP Application
We have noticed that since the release of V2.06 DM Smart DSP that some people are unable to communicate between their DSP and the DM Smart DSP application. We have created this article to hopefully...
-
Josh Cramer created an article,
Making your own PFM module
There are times that we may not have the specific PFM module you may want to make your system just the way you want it! This article will give you a breakdown of how you can obtain the correct part...
-
Josh Cramer created an article,
Legacy DM Smart DSP versions
Listed below is the Legacy version of the DM Smart DSP. You should only install this version if instructed by Technical Services or in case of a complete unit lockup. DM Smart DSP V1.3.69 Windows...
-
Josh Cramer created an article,
Active vs Passive Crossovers in an Audio Systems - What's the difference?
Many people call our wonderful tech support agents looking for options and recommendations for the awesome audio system they want to build! We always love helping our customers understand the poten...
-
Josh Cramer created an article,
Three.2 Crossover settings (bypass and normal)
The Three.2 features a 24dB/Octave crossover which acts as a high pass on the front and rear channels, and a low pass for the subwoofer channel. Jumpers inside the Three.2 allow you to bypass the c...
-
Josh Cramer created an article,
There is no output on the channel 3/sub output on my LC6i/LC7i/LCQ-1
There are only 2 ways to get output on channel 3 of either the LC6i, LC7i or LCQ-1. Either you send signal IN to the channel 3 input, or you send signal IN to the channel 2 input and you have AutoM...
-
Josh Cramer created an article,
My AudioControl line converter suddenly will no longer turn on
If your AudioControl line converter is not turning on, there are a couple of things to check to narrow down the cause. If you are using the GTO signal sensing to turn the line converter on, we will...
-
Josh Cramer created an article,
My Line out Converter stays on after the car turns off when using the GTO signal sense
Our GTO signal sense operates by detecting a specific carrier wave coming from the vehicle’s head unit. This can cause a situation where the factory head unit of the vehicle may send that signal to...
-
Josh Cramer created an article,
After installing your line out converter my door chimes are VERY loud!
Since we have no way to control the volume level of the door chimes out of the factory system, the only answer is to adjust the gain staging between the converter and the aftermarket amp to minimi...
-
Josh Cramer created an article,
I just hooked up the Epicenter, but it’s only outputting low muffled noise.
This is most likely caused by not sending a full frequency signal to the Epicenter®. Did you connect the Epicenter to a dedicated sub channel? If so, this might be your problem. You need to send ...