Check your inputs and outputs.
If you connect the high speaker inputs, and then accidentally connect your cables to the RCA inputs, instead of the RCA outputs, the DM processor will still pass the signal thru giving the illusion that the audio is going thru the processor.
The audio will tend to be noisy and not that loud, but it will be there. The DM Smart DSP software will not be able to adjust the audio because the audio is coming out of the inputs, not the outputs.
Yes, this is confusing, but true.
Comments
1 comment
Hi my question is that it stuck on downloading data and the communication light isn’t flashing. When I enter the pin 1234 it flashes but nothing after that. The default com is com4 on serial IO in device manager, 9600/8/n1 via usb. I tried multiple cables , pc’s, and 2 versions of software. I know the software send wake command and initialize the dm810 and accept 1234, because I tried other codes to verify rejection. But again it’s stuck on downloading data from dm810
Please sign in to leave a comment.